restrict device by mac address only to a certain switch

rstanila
rstanila Posts: 10
First Anniversary First Comment

Hello

I have 4 switches managed in Nebula CC.

3 of them are connected to a main switch. This main switch also is connected to a router and internet.

How can I restrict one POE device (camera) to only one switch (one of the 3 above) ?

If by mistake I connect this POE device to any of the other 3 switches, I need the system to block the trafic.

All Replies

  • Zyxel_Melen
    Zyxel_Melen Posts: 1,629  Zyxel Employee
    First Anniversary 10 Comments Friend Collector First Answer

    Hi @rstanila,

    May I know which model are you using? It would be better for us to help investigate the solution.

    Zyxel Melen

  • rstanila
    rstanila Posts: 10
    First Anniversary First Comment

    Hello

    we have the poe device connected to GS1915-8EP switch.

    the other 3 are GS1915-8EP, 1920- 24HP and 1920-48 HP

  • Zyxel_Melen
    Zyxel_Melen Posts: 1,629  Zyxel Employee
    First Anniversary 10 Comments Friend Collector First Answer

    Hi @rstanila,

    Apologise for the late reply.

    After investigation, Nebula could not provide you with a method to restrict a device that can only connect to a specific switch. However, the camera normally won't unplug and then plug into other switches after deployment. Is this requirement to prevent you connect the camera to the wrong switch during the deployment?

    Could you share more detailed information about your scenario?

    Zyxel Melen

Nebula Tips & Tricks