[SCR]How to set up NAT rule for SCR device on Nebula?
To configure a NAT rule for your SCR device on Nebula, follow these steps:
1. Go to Site-wide > Configure > Security router > Firewall in your Nebula dashboard.
2. Click on "ADD" to create a new NAT rule and provide the following information:
Public port: Specify the port number on the public IP address that you want to map to the internal SCR device.
LAN IP: Enter the LAN IP address of the SCR device to which the traffic will be forwarded.
Local Port: Indicate the port number on the internal SCR device that should receive the forwarded traffic.
3. Click "Save" to save and apply the NAT rule configuration for your SCR device.
By following these steps, you can successfully set up a Network Address Translation (NAT) rule on your SCR device, enabling external communication to a specific service.
Categories
- All Categories
- 397 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 81 Nebula Status and Incidents
- 5.2K Security
- 93 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 921 WirelessLAN
- 35 WLAN Ideas
- 5.9K Consumer Product
- 211 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2K FAQ
- 938 Nebula FAQ
- 425 Security FAQ
- 238 Switch FAQ
- 210 WirelessLAN FAQ
- 47 Consumer Product FAQ
- 139 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight