[ATP/FLEX] How to add the last Optional port to LAN Group1?






Once you have successfully executed ZTP (Zero Touch Provisioning), if you wish to exclusively use the LAN1 subnet while facing difficulty in saving the last optional port to LAN1, refer to the illustration below:
Why cannot save it?
This issue arises due to the firewall's default configuration, which comprises two LAN Groups and LAN subnets, with the last optional port residing in LAN Group2. To address this, users are required to eliminate the LAN2 subnet and remove LAN Group2, followed by configuring the last optional port within LAN Group1.
How to resolve it?
Follow these steps:
STEP1. Navigate to Site-wide > Configure > Firewall > Interface and remove the lan2 subnet.
STEP2. Proceed to Site-wide > Configure > Firewall > Port, and remove LAN Group 2.
STEP3. Configure the last optional port to belong to LAN Group 1, and ensure to save the changes.
Done. By following these steps, the problem should be resolved.
Click here to start:
Categories
- All Categories
- 300 Beta Program
- 1.9K Nebula
- 103 Nebula Ideas
- 72 Nebula Status and Incidents
- 4.8K Security
- 4 USG FLEX H Series
- 242 Security Ideas
- 1.1K Switch
- 54 Switch Ideas
- 807 WirelessLAN
- 29 WLAN Ideas
- 5.5K Consumer Product
- 178 Service & License
- 309 News and Release
- 69 Security Advisories
- 19 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.3K FAQ
- 556 Nebula FAQ
- 349 Security FAQ
- 118 Switch FAQ
- 147 WirelessLAN FAQ
- 33 Consumer Product FAQ
- 114 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 70 About Community
- 56 Security Highlight