My AP were taken over by Nebula - how can I access them?

mde
mde Posts: 2
First Comment

Hi,

my 2 APs have been taken over by Nebula. I would prefer to administrate them on my own.
Currenlty, I cannot access them from the local network. As I registered on Nebula, I was able to register the APs, but I was never able to access them.
After unregistering them from Nebula, I still cannot access them.

How can I regain the access to the APs?

Thanks for your support.

Accepted Solution

  • Zyxel_Judy
    Zyxel_Judy Posts: 608
    Zyxel Certified Network Engineer Level 2 - Security Zyxel Certified Network Engineer Level 1 - WLAN Zyxel Certified Network Engineer Level 1 - Security Zyxel Certified Network Administrator - WLAN
     Zyxel Employee
    Answer ✓

    Hi there,

    Have you attempted to reset the AP yet? If not, please follow the procedure below to restore the AP to its factory-default settings.

    Step-by-Step:

    1. Make sure the AP Power LED is on and not blinking.
    2. Press the RESET button and hold it until the Power LED begins to blink. (This usually takes about ten seconds.)
    3. Release the RESET button and wait for the Zyxel Device to restart.

    You should be able to access the Zyxel Device in standalone mode using the default settings.

    Note: This procedure removes the current configuration.

    Click here to start: https://bit.ly/46UJJCE

    Judy

All Replies

  • Zyxel_Judy
    Zyxel_Judy Posts: 608
    Zyxel Certified Network Engineer Level 2 - Security Zyxel Certified Network Engineer Level 1 - WLAN Zyxel Certified Network Engineer Level 1 - Security Zyxel Certified Network Administrator - WLAN
     Zyxel Employee
    Answer ✓

    Hi there,

    Have you attempted to reset the AP yet? If not, please follow the procedure below to restore the AP to its factory-default settings.

    Step-by-Step:

    1. Make sure the AP Power LED is on and not blinking.
    2. Press the RESET button and hold it until the Power LED begins to blink. (This usually takes about ten seconds.)
    3. Release the RESET button and wait for the Zyxel Device to restart.

    You should be able to access the Zyxel Device in standalone mode using the default settings.

    Note: This procedure removes the current configuration.

    Click here to start: https://bit.ly/46UJJCE

    Judy

  • mde
    mde Posts: 2
    First Comment

    Thanks Judy for your answer!

    Yes, usually it would be a reasonable option. Before I lose all my settings, I would prefer to try something else. An idea?

    Kind regards,

    Mariusz

  • Zyxel_Judy
    Zyxel_Judy Posts: 608
    Zyxel Certified Network Engineer Level 2 - Security Zyxel Certified Network Engineer Level 1 - WLAN Zyxel Certified Network Engineer Level 1 - Security Zyxel Certified Network Administrator - WLAN
     Zyxel Employee

    Hi Mariusz,

    Typically, when you unregister the APs from Nebula, the existing configurations are automatically replaced with the default settings. To proceed, simply reset your APs and then verify if you can access the local configuration interface of your AP.

    Click here to start: https://bit.ly/46UJJCE

    Judy

Nebula Tips & Tricks