USG20 VPN setup
Im bit new about configuring any router/firewall. I managed to setup SSL VPN and connect with secureExtender to it. But My ip remains same what i use without VPN.
There is so many setups that im not sure anymore that what else i have to do to get my VPM server ip in use for my client?
There is so many setups that im not sure anymore that what else i have to do to get my VPM server ip in use for my client?
0
All Replies
-
Hi @Biletti,
Go to CONFIGURATION > VPN > SSL VPN > Access Privilege and click "Add".1. Create a new user.
2. After the new user is created, move it to “Selected User”.
3. Create an IP pool for SSL VPN users. Note that the subnet cannot conflict with any WAN/LAN/DMZ/WLAN even if they are not in use.4. Select SSL_pool as Assign IP Pool. In Network List, select which subnet can be accessed by the SSL VPN users.
5. On SecuExtender, enter the USG’s WAN IP, username and password you created on the USG.
SSL VPN is connected.0 -
Hi @Zyxel_Emily
Thanks for quick reply!
I have managed to do that, i can connect to my SSL VPN via secureexnteder client, but mu public ip is still different as my server?
It should be same as the server ip?
0 -
Hi @Biletti,
Enable “Force all client traffic to enter SSL VPN tunnel” and the SSL VPN client’s IP address is the same as USG20-VPN’s IP.
0
Categories
- 8.5K All Categories
- 1.6K Nebula
- 72 Nebula Ideas
- 57 Nebula Status and Incidents
- 4.5K Security
- 227 Security Ideas
- 985 Switch
- 46 Switch Ideas
- 882 WirelessLAN
- 24 WLAN Ideas
- 5.2K Consumer Product
- 158 Service & License
- 280 News and Release
- 61 Security Advisories
- 13 Education Center
- 581 FAQ
- 263 Nebula FAQ
- 160 Security FAQ
- 76 Switch FAQ
- 75 WirelessLAN FAQ
- 7 Consumer Product FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 62 About Community
- 46 Security Highlight