USG20 VPN setup

Biletti
Biletti Posts: 2
Friend Collector First Comment
edited April 2021 in Security
Im bit new about configuring any router/firewall. I managed to setup SSL VPN and connect with secureExtender to it. But My ip remains same what i use without VPN.

There is so many setups that im not sure anymore that what else i have to do to get my VPM server ip in use for my client?

All Replies

  • Zyxel_Emily
    Zyxel_Emily Posts: 1,280  Zyxel Employee
    First Anniversary 10 Comments Friend Collector First Answer

    Hi @Biletti,


    Go to CONFIGURATION > VPN > SSL VPN > Access Privilege and click "Add".
    1. Create a new user.


    2. After the new user is created, move it to “Selected User”.

    3. Create an IP pool for SSL VPN users. Note that the subnet cannot conflict with any WAN/LAN/DMZ/WLAN even if they are not in use.


    4. Select SSL_pool as Assign IP Pool. In Network List, select which subnet can be accessed by the SSL VPN users.

    5. On SecuExtender, enter the USG’s WAN IP, username and password you created on the USG.

    SSL VPN is connected.

  • Hi @Zyxel_Emily

    Thanks for quick reply!

    I have managed to do that, i can connect to my SSL VPN via secureexnteder client, but mu public ip is still different as my server?



    It should be same as the server ip?
  • Zyxel_Emily
    Zyxel_Emily Posts: 1,280  Zyxel Employee
    First Anniversary 10 Comments Friend Collector First Answer

    Hi @Biletti,

     

    Enable “Force all client traffic to enter SSL VPN tunnel” and the SSL VPN client’s IP address is the same as USG20-VPN’s IP.



Security Highlight