How should I set PoE Timerange on Zyxel switch(V4.80 version)?





1. Go to SYSTEM> Time Range, firstly, type in the name of the profile, and then choose which type you would prefer to use "Absolute" or "Periodic", after configuring remember to click the "Apply" button.
Note: You may click the "Help" button in the upper right corner for detailed information.
2. After clicking the "Apply" button, the profile will be listed in the Time Range table.
3. Go to PORT>PoE Setup > PoE Time Range Setup to apply the profile to a switch port.
Input which port you would like to apply the profile, click on the profile name, and then click "Apply" button
4. On the mid center are the port list and time range profiles table where you can check if the profile is successfully applied.
5. Remember to click on "Save" button in the upper right corner to save all the settings.
Tips for verification:
1. You may go to PORT >PoE Setup >PoE Status;
If the time hasn't arrived yet for PoE, you will see that the time-range state is "Out"and port and state is "Disable"
When the time comes, the time-range state should be "In (profile name)"and the State should be Enable.
Categories
- All Categories
- 429 Beta Program
- 2.6K Nebula
- 163 Nebula Ideas
- 112 Nebula Status and Incidents
- 6K Security
- 350 USG FLEX H Series
- 291 Security Ideas
- 1.5K Switch
- 78 Switch Ideas
- 1.2K Wireless
- 42 Wireless Ideas
- 6.6K Consumer Product
- 261 Service & License
- 407 News and Release
- 87 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 3.8K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 82 Security Highlight