Settings for 802.1p Priority in Nebula

Niro96

Hello,

Is there a way to configure the priority of the GS1920 ports in Nebula?

greeting
Marcus

Zyxel_Melen

Hi @Niro96,

You can assign a specific VLAN for these individual IP addresses and set the quality of service for this VLAN to achieve your purpose. If these individual IP addresses are assigned to the devices with the same OUI, you can use vendor ID based VLAN for this task.

Niro96

Ok. Thank you.

greeting Marcus

Zyxel_Melen

Hi @Niro96,

In addition, when the switch is in cloud mode, you can change the port priority on the local GUI. For specific IP addresses, please reference the above suggestion.

Zyxel_Melen

Hi @Niro96,

Currently, Nebula does not support 802.1p on the switch port setting page. But you can configure 802.1p on Site-wide > Configure > Switches > Switch settings page.

Please reference the options below:

• Quality of service

• Voice VLAN
  LLDP-MED:

OUI:

• Vendor ID based VLAN

Hope it helps.

Niro96

Hello,

Thank you for the info. Can I then prioritize individual IP addresses/ports?
With Vendor ID based VLAN?

greeting
Marcus

Zyxel_Melen

Hi @Niro96,

You can assign a specific VLAN for these individual IP addresses and set the quality of service for this VLAN to achieve your purpose. If these individual IP addresses are assigned to the devices with the same OUI, you can use vendor ID based VLAN for this task.

Niro96

Ok. Thank you.

greeting Marcus

Zyxel_Melen

Hi @Niro96,

In addition, when the switch is in cloud mode, you can change the port priority on the local GUI. For specific IP addresses, please reference the above suggestion.