SecuExtender IpSec tunnel to USG Flex 200

Installed SecuExtender 7.7.40 on a notebook and tried to create an IPSEC tunnel to the USG FLEX 200 firewall.
It does not work with the wizard on USG and SecuExtender, have therefore tried to manually set up a VPN tunnel, even if the parameters are the same on USG and SecuExtender, it does not work.
It works fine on another PC with an earlier perputual version of secuextender.
Does anyone have a guide?

All Replies

  • smb_corp_user
    smb_corp_user Posts: 163  Master Member
    5 Answers First Comment Friend Collector Second Anniversary

    I do not remember the specifics, but in theory it could possibly be a case of the current firmware on the USG not supporting communication with your new version of the SecuExtender.

  • Zyxel_Jeff
    Zyxel_Jeff Posts: 1,206  Zyxel Employee
    100 Answers 500 Comments Friend Collector Fourth Anniversary


    Don't miss this great chance to upgrade your Nebula org. for free! https://bit.ly/4g2pS9L

  • Zyxel_Jeff
    Unfortunately I get a server error.
    Port 443 is NAT to server behind firewall, have tried to NAT other port to firewall's internal IP, no luck.

  • Zyxel_Jeff
    Zyxel_Jeff Posts: 1,206  Zyxel Employee
    100 Answers 500 Comments Friend Collector Fourth Anniversary

    Hi @KimKjelmann

    OK, noted. Alternatively, could you import the .tgb file into the SecuExtender for an alternative solution? It shall be working for you. Thanks.


    Don't miss this great chance to upgrade your Nebula org. for free! https://bit.ly/4g2pS9L

Security Highlight