Vlan tagging on Wan interface

Alfonso

Hi

I am testing a Nebula device.

I was not able to configure a vlan tagging on wan interface. So the device is not able to reach the nebula center.
I did not find any CLI document for NSG devices.

I am able to connect to the device via console port, so i think i will able to configure the vlan tagging on wan interface if a cli reference guide will be delivered.

Regards

Zyxel_Jason

Hi @Alfonso,

Currently, NSG only support VLAN tagging on LAN interface, not on WAN interface.
I will move this topic to Idea section.

Thanks.

Zyxel_Jason

Hi @Alfonso,

Good news!

After checking, we already have that feature in our future road map.

Thanks.

Alfonso

Great news, thanks @Nebula_Jason

Alfonso

HI @Nebula_Jason

Do you know when this feature will be delivered?

Zyxel_Jason

Hi @Alfonso ,

The schedule of the feature will be in the first half of 2020.

Hope it helps.

Alfonso

Hi @Nebula_Jason

Do you have a more specific ETA?

Zyxel_Jason

Hi @Alfonso ,

The current schedule for this feature "VLAN tagging for WAN Interface" is around middle of January, 2020.?

Thanks.

Alfonso

Thanks @Nebula_Jason

I will ask again around middle of January :)

Nebula_Bayardo

Hey @Alfonso

I guess you already know but just to make it official here ?. The VLAN tag on WAN has been supported in the last firmware available by the middle of January.

Similarly to setting up the WAN IP address, this is available in the device local GUI only as normally this setting will be applied when the device is getting installed.

Hope you are already making use of it ?