How to Configure Zyxel NWA50AX Access Points for Guest Network DHCP?

Zyxel_Jay

Question:

How can I configure my Zyxel NWA50AX access points so that WiFi clients receive IP addresses directly from my DHCP server in the guest network?

Answer:

If you wish to configure your NWA50AX access points to enable WiFi clients to receive IP addresses from your DHCP server in the guest network, follow these steps:

1. Access the Nebula Control Center.
2. Go to the NWA50AX device settings.
3. Set the corresponding Guest VLAN on the SSID.
4. Ensure that the traffic will be directed by the Gateway (GW) itself.
5. Check the settings on the GW to verify any AP bypass for communication with the NCC.

By following these steps, you can configure your NWA50AX access points to allow WiFi clients to receive IP addresses from your DHCP server in the guest network.