dyndns refresh button
Hi,
The USG have a "refresh" feature under logs, for refreshing dyndns connections (ip change)
And we have customer in a situation where reading the wan interface is not a good enough solution for dyndns.
So to resolve it today, I have to turn off dyndns, save, then enable, and save, for it to refresh.
But since the USG already had a refresh button, can that be added in the future?
Because the customer have to use 3rd party router, as in devices that does not support bridge mode and such, the dyndns cannot read the ip change from the wan port/interface, so no means of getting this to work automatic.
However a refresh button would make life simpler.
The USG have a "refresh" feature under logs, for refreshing dyndns connections (ip change)
And we have customer in a situation where reading the wan interface is not a good enough solution for dyndns.
So to resolve it today, I have to turn off dyndns, save, then enable, and save, for it to refresh.
But since the USG already had a refresh button, can that be added in the future?
Because the customer have to use 3rd party router, as in devices that does not support bridge mode and such, the dyndns cannot read the ip change from the wan port/interface, so no means of getting this to work automatic.
However a refresh button would make life simpler.
1
Categories
- 8.1K All Categories
- 1.6K Nebula
- 60 Nebula Ideas
- 54 Nebula Status and Incidents
- 4.4K Security
- 224 Security Ideas
- 963 Switch
- 45 Switch Ideas
- 868 WirelessLAN
- 20 WLAN Ideas
- 5.2K Consumer Product
- 139 Service & License
- 268 News and Release
- 53 Security Advisories
- 12 Education Center
- 573 FAQ
- 273 Nebula FAQ
- 132 Security FAQ
- 73 Switch FAQ
- 72 WirelessLAN FAQ
- 7 Consumer Product FAQ
- Documents
- 34 Nebula Monthly Express
- 71 About Community
- 44 Security Highlight