[NEBULA] GS1920-8HP connected to Nebula - Unable to access local login


Best Answers
-
It should work, does switch reply when ping to it?5
-
@Quality_Drive_Away
You should be able to connect to the IP interface of GS1920-8HP and the username/password will be the configuration from Nebula in the General Settings.
5
All Replies
-
Found it! Thank You!2
-
I joined my NWA1123 wifi access point to nebula and now I can't log in locally. Tried with both my original username & password as well as the username & password I use on the nebula website.
I don't see General Settings in the Nebula Control Settings.
0 -
Hi @flaccidupsilon ,
Welcome Zyxel community!
If your AP is online on NCC, you should be able to find your username and password in General setting page, location is at SITE-WIDE>Configure>General setting, then you can find the setting like below.
Hope it helps.
Jason0 -
Thanks, that does help. I'm in now.
Two points: I didn't realize that my local password would be changed by connecting to Nebula. Second, you're the first to mention "SITE-WIDE", which was the key to finding General Settings.
Thanks again Jason!
1
Categories
- 6.9K All Categories
- 2 Education Center
- 1.4K Nebula
- 34 Nebula Ideas
- 40 Nebula Status and Incidents
- 3.9K Security
- 203 Security Ideas
- 751 Switch
- 31 Switch Ideas
- 632 WirelessLAN
- 10 WLAN Ideas
- 4.6K Consumer Product
- 105 Service & License
- 223 News and Release
- 39 Security Advisories
- 522 FAQ
- 239 Nebula FAQ
- 121 Security FAQ
- 73 Switch FAQ
- 67 WirelessLAN FAQ
- 6 Consumer Product FAQ
- Documents
- 30 Nebula Monthly Express
- 44 About Community
- 32 Security Highlight