Resetting NWA55AXE to factory default

mzurhorst

Hi.

I am looking for a way to set the NWA55AXE to factory default. I do still have access to the device (in stand-alone mode), and I want to purge my config because I like to sell the AP.

I only found this instruction below.

Is this really the only way that I now have to oder a new Zyxel switch for the "neighboring" function and send this back 5 minutes later? - Seriously?

Is there anything I can do with SSH access? — From the UI, I do not find any button to set back to factory default.

Thank you.

https://community.zyxel.com/en/discussion/24001/how-to-reset-the-nwa55axe-to-factory-default-settings

Zyxel_Judy

Hi @mzurhorst ,

You can reset the NWA55AXE to its default settings via SSH by using the following command

apply /conf/system-default.conf

For more detailed information on the NWA55AXE CLI commands, please refer to the CLI Reference Guide here NWA55AXE_V6.29_V6.65.pdf (zyxel.com)

Zyxel_Judy

Hi @mzurhorst ,

You can reset the NWA55AXE to its default settings via SSH by using the following command

apply /conf/system-default.conf

For more detailed information on the NWA55AXE CLI commands, please refer to the CLI Reference Guide here NWA55AXE_V6.29_V6.65.pdf (zyxel.com)