How can I enter command mode when 'Hit Any Key to Stop Autoboot' appears?
Zyxel_Jami
Posts: 127 Zyxel Employee
in Other Topics
To enter command mode on your Zyxel AP during the boot process, follow these steps:
- Use a console connection (e.g., via Tera Term) to monitor the AP's boot process.
- When the message 'Hit any key to stop autoboot' appears, press any key on your keyboard.
- This interrupts the automatic boot process and enters the bootloader's command mode.
Once in command mode, you will see a prompt (e.g., =>
) where you can enter various commands.
To view the available commands, type: help
This will display a list of commands to control the boot process or configure the system.
Please refer following image:
0
Categories
- All Categories
- 415 Beta Program
- 2.4K Nebula
- 152 Nebula Ideas
- 100 Nebula Status and Incidents
- 5.8K Security
- 288 USG FLEX H Series
- 278 Security Ideas
- 1.5K Switch
- 77 Switch Ideas
- 1.1K Wireless
- 42 Wireless Ideas
- 6.5K Consumer Product
- 252 Service & License
- 396 News and Release
- 85 Security Advisories
- 29 Education Center
- 10 [Campaign] Zyxel Network Detective
- 3.6K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 86 About Community
- 75 Security Highlight