LED is blinking on smart mesh repeater AP
Options
Zyxel_JoyLee
Posts: 123 
Zyxel Employee
Zyxel Employee
Light blue blinking on your Zyxel Repeater AP indicates that the device is currently searching for an uplink signal. This is part of the normal setup process when deploying a mesh network. Make sure your repeater AP is in the signal covered area of root AP.
If this happens when root AP and repeater AP are close to each other, make sure both APs are registered in the same Nebula Organization and site. In addition, check event log of root AP to get more information about Smart Mesh connection process.
0
Categories
- All Categories
- 442 Beta Program
- 2.9K Nebula
- 219 Nebula Ideas
- 127 Nebula Status and Incidents
- 6.5K Security
- 602 USG FLEX H Series
- 344 Security Ideas
- 1.7K Switch
- 84 Switch Ideas
- 1.4K Wireless
- 52 Wireless Ideas
- 7K Consumer Product
- 298 Service & License
- 481 News and Release
- 92 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4.8K FAQ
- 34 Documents
- 87 About Community
- 105 Security Highlight