[NR7302] IP passthrough not working



I'm running the device on 1.00(ACHA.4)b5_F0 and it's connected to the Telekom network in Germany.
I'm trying to get IP passthrough working correctly. So I connected it to a dedicated port on a OpenWRT router and IP passthrough is set to dynamic mode.
I can see that the mode is enabled and the device even shows the associated IPv4 address.
But the OpenWRT doesn't receive the address via DHCP. With tcpdump on the interface I can monitor the broadcasts but no answers come through.
There was a hint about disabling the firewall on the Zyxel but I don't see any difference.
Anyone with success who can assist me?
All Replies
-
OK, the solution was simple, and maybe I missed it in the manual.
On the bridge itself containing the APN, DHCP must be active, even if there is no particular interest in the network. For management reasons, I connect to the device via WiFi or one of the VLANs tagged.
My understanding was that IP passthrough would serve DHCP requests.
In case, somebody else encounters the same problem.
1
Categories
- All Categories
- 434 Beta Program
- 2.7K Nebula
- 174 Nebula Ideas
- 117 Nebula Status and Incidents
- 6.1K Security
- 418 USG FLEX H Series
- 297 Security Ideas
- 1.6K Switch
- 78 Switch Ideas
- 1.2K Wireless
- 43 Wireless Ideas
- 6.7K Consumer Product
- 269 Service & License
- 416 News and Release
- 87 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4.1K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 84 About Community
- 87 Security Highlight