How to enable sFlow on Zyxel cloud mode switch?

Zyxel_HsiuTe
Posts: 28
Zyxel Employee





If you are looking to enable sFlow on Zyxel cloud mode switches, it is important to confirm that your specific model supports this feature. Currently, the Zyxel XS3800-28 switch supports sFlow.
Please note that the Nebula Control Center does not support configuring sFlow directly, but you can manually enable it using the CLI (Command Line Interface).
Additionally, sFlow configuration will be retained locally on the switch.
Follow these steps to configure sFlow via CLI:
- Access the CLI of your Zyxel XS3800-28 switch.
- Enter the following commands:
config
sflow
sflow collector <ip-address> [udpport <udp-port>]
interface port-channel <port-list>
sflow
sflow collector <ip-address> - Once configured, use the command
show sflow
to review the sFlow settings.
If you encounter any other issues, please help create a post here
and tag @Zyxel_CSO , or create a ticket
directly to reach us.
0
Categories
- All Categories
- 431 Beta Program
- 2.6K Nebula
- 165 Nebula Ideas
- 112 Nebula Status and Incidents
- 6K Security
- 364 USG FLEX H Series
- 292 Security Ideas
- 1.5K Switch
- 78 Switch Ideas
- 1.2K Wireless
- 42 Wireless Ideas
- 6.6K Consumer Product
- 262 Service & License
- 407 News and Release
- 87 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 3.9K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 83 Security Highlight