[NEBULA] How to use NAT mode on AP?
Options

Zyxel_JoyLee
Posts: 62
Zyxel Employee


in SSID
Where to find:
Configure > Access point > SSID advanced settings > Traffic options
Function description: NAT mode is used to have the AP create a DHCP subnet with its own NAT for the SSID. Provide minimum hardware requirement for Wi-Fi of small shop/café
If AP management IP address is NOT part of “10.0.0.0/8”, SSID subnet becomes “10.0.0.0/8”.
If AP management IP address is part of “10.0.0.0/8”, SSID subnet becomes “172.16.0.0/12”
Scenario: Enable NAT mode on the SSID which is provided for Guest usage.
Configuration:
- Go to Configure > Access points> SSID settings. Add to SSID as "Wi-Fi". Then click "Edit".
Or Configure > Access points > SSID advanced settings then select the SSID to continuing the setting.
2. Configure the Traffic options, enable "NAT mode" and click "Back"
3. Click "Save".
Successful Log.
Note.
- The following AP features do not work when NAT mode is on.
a. 802.11r
b. Layer2 isolation
c. Dynamic VLAN (cloud authentication, RADIUS server) - When NAT mode is enabled on non-supported models, Nebula CC does not show any error message. And non-supported models disable any SSID with NAT mode enabled.
- The IP address lease time is 8 hours.
Tagged:
0
Categories
- All Categories
- 434 Beta Program
- 2.7K Nebula
- 174 Nebula Ideas
- 117 Nebula Status and Incidents
- 6.1K Security
- 417 USG FLEX H Series
- 297 Security Ideas
- 1.6K Switch
- 78 Switch Ideas
- 1.2K Wireless
- 43 Wireless Ideas
- 6.7K Consumer Product
- 269 Service & License
- 416 News and Release
- 87 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4.1K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 83 About Community
- 87 Security Highlight