How do I replicate a USG 100HP configuration on Nebula?

henriquev

Hello,

I need to apply a baseline configuration to 549 new sites using the USG 100HP firewall model on Nebula.

I have tried using the "clone site" feature, which works for us with the USG Flex 200 model, but it is not working for the USG 100HP. When I clone a site, the new firewall's configuration in Nebula appears blank. I also attempted to restore a configuration backup, which was also unsuccessful.

Could you please provide guidance on the correct procedure for replicating a configuration across multiple USG 100HP sites?

Zyxel_Tina

Hi @henriquev,

Currently, the FLEX H series does not support the clone site feature, which is why you encountered the clone failure issue.

Workaround:

When onboarding the new firewall, please choose “Web configure” for the first-time deployment.

Then, go to the following page to restore the configuration file — this will allow the device to recover the same settings as your previous unit.

Zyxel_Tina

Hi @henriquev,

Currently, the FLEX H series does not support the clone site feature, which is why you encountered the clone failure issue.

Workaround:

When onboarding the new firewall, please choose “Web configure” for the first-time deployment.

Then, go to the following page to restore the configuration file — this will allow the device to recover the same settings as your previous unit.