[NEBULA] Wie kann ich einem Client eine Feste IP mit dem NSG zuweisen
Accepted Solution
-
Hi @Gr33n93,
Welcome yo Zyxel Community!!
You may configure the fixed IP to a client through DHCP setting as steps below:
1) Go to GATEWAY -> Configure -> Interface addressing, choose which LAN interface example as below is LAN2, and then click "Edit"
2) In the DHCP setting, click "Add new" under "Static DHCP Table".
3) You may now assign an IP to the specific client by inputting the MAC-address as figure below, and then click "OK".
4) Remember to click the "Save" button after the settings.
Sincerely yours,
Jonas
Jonas,5
All Replies
-
Hi @Gr33n93,
Welcome yo Zyxel Community!!
You may configure the fixed IP to a client through DHCP setting as steps below:
1) Go to GATEWAY -> Configure -> Interface addressing, choose which LAN interface example as below is LAN2, and then click "Edit"
2) In the DHCP setting, click "Add new" under "Static DHCP Table".
3) You may now assign an IP to the specific client by inputting the MAC-address as figure below, and then click "OK".
4) Remember to click the "Save" button after the settings.
Sincerely yours,
Jonas
Jonas,5
Categories
- All Categories
- 426 Beta Program
- 2.6K Nebula
- 163 Nebula Ideas
- 112 Nebula Status and Incidents
- 6K Security
- 345 USG FLEX H Series
- 289 Security Ideas
- 1.5K Switch
- 78 Switch Ideas
- 1.2K Wireless
- 42 Wireless Ideas
- 6.6K Consumer Product
- 261 Service & License
- 404 News and Release
- 86 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 3.8K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 82 Security Highlight