Block client

HummervikenITAB

How do I from the Nebula Control Center permanently block a client from using the network (both for wired and wireless devices)?

Zyxel_Chris

Hello @HummervikenITAB

For wireless user you can block it in Access point>Monitor>Clients, select the client in policy then block. You can also select "Normal" to unlock.

For the wired user you can use ACL in Switch>Configure>ACL (type target MAC address in source MAC address), please be aware that it is the site-wide setting if you have 3 switch in this site then the ACL configuration will apply on all the switch.

Zyxel_Chris

@HummervikenITAB

Sorry, but in current stage we do not support it in schedule, but I can put this input to the idea section and anyone who like this idea can press like button or leave the comment below.?

Zyxel_Chris

Hello @HummervikenITAB

For wireless user you can block it in Access point>Monitor>Clients, select the client in policy then block. You can also select "Normal" to unlock.

For the wired user you can use ACL in Switch>Configure>ACL (type target MAC address in source MAC address), please be aware that it is the site-wide setting if you have 3 switch in this site then the ACL configuration will apply on all the switch.

HummervikenITAB

Thank you Chris,

This was exactly what I was looking for.

Is there any way to schedule rules for these settings?

Zyxel_Chris

@HummervikenITAB

Sorry, but in current stage we do not support it in schedule, but I can put this input to the idea section and anyone who like this idea can press like button or leave the comment below.?