USG-200: WAN to VLAN IP Address

A_Boschetti

Hi all,
someone had experiense and knowledge on USG-200 about NAT on VLAN interface on LAN port?
I make VLANs on LAN port and police route and firewall/NAT rule but I can't reach from WAN to VLAN destination address.
Is possible to have an example about that feature?

Thanks
Best Regards,
Andrea Boschetti

jasailafan

It should be working. Here is an example to access RDP of a laptop in vlan.
vlan
zone- LAN1
base port- lan1

nat rule
Connect a laptop to vlan1. 
original ip- wan ip
laptop- 192.168.100.33


firewall rule
Add a rule 
from WAN to LAN1
destination- laptop's ip address
service- RDP
access- allow

Zyxel_Cooldia

@jasailafan, Thank for instruction. 

Hi @A_Boschetti,

Welcome to Zyxel Community.  Feel free to post your question here and we are more than happy to assist you.

You can follow @jasailafan instruction to set up NAT. 

BTW, there is no need to set up policy route for this, it may cause packet reply to wrong interface.