USG-200: WAN to VLAN IP Address
Options
A_Boschetti
Posts: 1
Hi all,
someone had experiense and knowledge on USG-200 about NAT on VLAN interface on LAN port?
I make VLANs on LAN port and police route and firewall/NAT rule but I can't reach from WAN to VLAN destination address.
Is possible to have an example about that feature?
Thanks
Best Regards,
Andrea Boschetti
someone had experiense and knowledge on USG-200 about NAT on VLAN interface on LAN port?
I make VLANs on LAN port and police route and firewall/NAT rule but I can't reach from WAN to VLAN destination address.
Is possible to have an example about that feature?
Thanks
Best Regards,
Andrea Boschetti
0
Comments
-
It should be working. Here is an example to access RDP of a laptop in vlan.
vlan
zone- LAN1
base port- lan1
nat rule
Connect a laptop to vlan1.
original ip- wan ip
laptop- 192.168.100.33
firewall rule
Add a rule
from WAN to LAN1
destination- laptop's ip address
service- RDP
access- allow
1 -
@jasailafan, Thank for instruction.Hi @A_Boschetti,Welcome to Zyxel Community. Feel free to post your question here and we are more than happy to assist you.You can follow @jasailafan instruction to set up NAT.BTW, there is no need to set up policy route for this, it may cause packet reply to wrong interface.0
Categories
- All Categories
- 397 Beta Program
- 2.1K Nebula
- 116 Nebula Ideas
- 78 Nebula Status and Incidents
- 5.1K Security
- 52 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 70 Switch Ideas
- 907 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 211 Service & License
- 332 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 880 Nebula FAQ
- 415 Security FAQ
- 221 Switch FAQ
- 195 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 73 About Community
- 63 Security Highlight