My WRE2205 v1 will not reset

Mike0988
Posts: 1
I updated to the most current verion of firmware and now my unit doesn't work. The Signal light does not illuminate at all and I cannot reset the unit. The Power and WiFi lights are on constant (no blinking). When I connect via Ethernet cable the LAN light blinks, but I am not able to bring up the configuration for the unit.
#WRE_Jul_2020
#WRE_Jul_2020
0
All Replies
-
Have you press the reset button for over 10 seconds, and the power light will blink.
Then the IP of WRE will back to default, and that will be 192.168.1.2
You will have to set your PC to the same IP subnet, such as 192.168.1.100/255.255.255.0
Next, access to the webGUI by typing 192.168.1.2 on the browser.
0 -
Ok, that is clear now. Thank you for your answer.
0
Categories
- 8.1K All Categories
- 1.6K Nebula
- 60 Nebula Ideas
- 54 Nebula Status and Incidents
- 4.4K Security
- 224 Security Ideas
- 971 Switch
- 47 Switch Ideas
- 869 WirelessLAN
- 20 WLAN Ideas
- 5.2K Consumer Product
- 140 Service & License
- 268 News and Release
- 53 Security Advisories
- 12 Education Center
- 573 FAQ
- 273 Nebula FAQ
- 132 Security FAQ
- 73 Switch FAQ
- 72 WirelessLAN FAQ
- 7 Consumer Product FAQ
- Documents
- 34 Nebula Monthly Express
- 71 About Community
- 44 Security Highlight
Consumer Product Help Center
