[NEBULA] Allowed Remote IP
TCL_Support
Posts: 8 Freshman Member
I am trying to find a good manual that documents everything on the NGG100 gateway but so far have only found the user guide that is good for a general user but not at a network engineering level.
Currently I am trying to find out what I can put in the 'Allowed Remote IP' field under the NAT/Virtual Server rules. A single IP address in their works fine but we need to allow a range of addresses to access an open port, i.e. can we put in 51.140.0.0 to use a range of addresses or does it understand 51.140.0.0./14, etc.?
Currently I am trying to find out what I can put in the 'Allowed Remote IP' field under the NAT/Virtual Server rules. A single IP address in their works fine but we need to allow a range of addresses to access an open port, i.e. can we put in 51.140.0.0 to use a range of addresses or does it understand 51.140.0.0./14, etc.?
0
Comments
-
Hi @TCL_Support
Welcome to Nebula Forum!Yes, 51.140.0.0/14 can be understood! The format of Allowed Remote IP field can be as below; you can select one format to apply.
1. A specific ipv4 address, such as 51.140.0.0
2. A valid IP range, such as 51.140.0.0/14
3. Any: to allow any remote IP
0 -
Ok, perfect - at last a feature that works! Many thanks for the answer.
1
Categories
- All Categories
- 415 Beta Program
- 2.3K Nebula
- 141 Nebula Ideas
- 94 Nebula Status and Incidents
- 5.6K Security
- 218 USG FLEX H Series
- 262 Security Ideas
- 1.4K Switch
- 71 Switch Ideas
- 1K Wireless
- 39 Wireless Ideas
- 6.3K Consumer Product
- 245 Service & License
- 382 News and Release
- 81 Security Advisories
- 27 Education Center
- 8 [Campaign] Zyxel Network Detective
- 3.1K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 83 About Community
- 71 Security Highlight