[NEBULA] How to set up a Deny Group

Jim_Anderson
Jim_Anderson Posts: 2  Freshman Member
First Comment Third Anniversary
edited April 2021 in Nebula

I come from the USG series and utilized heavily the Address Group feature inside the Object-Address area to create a DENY_LIST which I could add various addresses that I did not want trying to access our network. Below is a similar group named ALLOW_LIST from one of our old USG's which had various IP's added to it.

Annotation 2020-03-05 104257.jpg

How is this duplicated on a NSG100? I cannot locate any method to create a deny list in it.


Thank you,

All Replies

  • Zyxel_Jonas
    Zyxel_Jonas Posts: 313  Zyxel Employee
    25 Answers First Comment Friend Collector Fifth Anniversary

    Hello @Jim_Anderson,

    Welcome to Zyxel Community!

    Nebula Gateway was designed for plug & play usage. There is no need to be complex to achieve your goal on NSG, please go to New Nebula => Security gateway => Configure => Firewall, as figure below. You may just add various addresses, and then select deny.

    Note: Please use comma sign "," to add more IP.

    image.png

    Hope it helps.

    Jonas

    Jonas,
  • Jim_Anderson
    Jim_Anderson Posts: 2  Freshman Member
    First Comment Third Anniversary

    Thank you. That works well. Is there anywhere here where a guide exists that would assist users familiar with USG configuring could reference that details how it should now be handled in NSG devices?

  • Zyxel_Jonas
    Zyxel_Jonas Posts: 313  Zyxel Employee
    25 Answers First Comment Friend Collector Fifth Anniversary
    edited March 2020

    Hi @Jim_Anderson,

    You are very welcome.

    For the guides, please refer to the link below: (starts at page 89)

    https://bulletin.nebula.zyxel.com/online-doc/nebula-cc/NCC_UG_v8.20_20200117.en-us.pdf

    Hope it helps

    -Jonas

    Jonas,

Categories

Nebula Tips & Tricks


    Read more

    Nebula Help Center

    EnglishTiếng ViệtРусскийไทย中文（台灣）