initial setup wizard

damianodec
damianodec Posts: 42  Freshman Member
First Comment Friend Collector First Anniversary
edited April 2021 in Security

Hi, on my USG40 when I try "initial setup wizard" and click on CONNECTION TEST I get:

"Connection type is detected as DHCP but internet connectivity has failed because the device cannot get an IP Address"

why?

(USG40 connect to ISP router by WAN Port P1)

thank you

All Replies

  • PeterUK
    PeterUK Posts: 3,459  Guru Member
    100 Answers 2500 Comments Friend Collector Seventh Anniversary

    How are you connected to your ISP? do you get the WAN IP or is the ISP router doing NAT.

    If you connect a PC to your ISP equipment do you get a IP WAN or LAN?

  • damianodec
    damianodec Posts: 42  Freshman Member
    First Comment Friend Collector First Anniversary

    when I connect Directly pc to ISP router I get 192.168.1.171 (router has DHCP 192.168.1.170 to 190)

  • Zyxel_Jerry
    Zyxel_Jerry Posts: 1,296  Zyxel Employee
    Zyxel Certified Network Administrator - Security Zyxel Certified Sales Associate 50 Answers 1000 Comments

    Hi @damianodec

    Can you try to collect the packet on WAN and LAN and check if there is any DHCP packet go through the interface?

    Here is the example how to collect packet.

    GO to Maintenance > Diagnostics > Packet Capture > Capture to select the Capture Interfaces > click Capture

    image001-red.png

    After doing the test, click stop and go to Maintenance > Diagnostics > Packet Capture > Files > select the files and click Download to check the packet on WAN & LAN

    image002-red.png


  • damianodec
    damianodec Posts: 42  Freshman Member
    First Comment Friend Collector First Anniversary

    hi @Zyxel_Jerry

    thank you for help.

    Now I connect by another ethernet port on ISP router. This is my configuration office:

    f1.JPG

    and it works.

    my internal Lan is 192.168.1.xxx - 255.255.255.0.

    on Wan1 gateway is 192.168.1.1 (ISP router).

    I configured a SSL VPN and if I use from my home Secure extender with:

    Server xxx.xxx.xxx.xxx:443 (xxx is my IP public) user and password

    It connects but I see just lan 192.168.6.xxx

    How can I to see lan 192.168.1.xxx ?

    thank you

Categories

Security Highlight


Read more

Security Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）