[092601]automatic Firmware update
Options
Comments
-
I just can say that it was working fine for me directly.
Got notification and upgrade went succesfull.
No manual restart needed.
Due to hat I was not at home when I start it, I couldn't tell you the LED state.
0 -
Red Blinking means FW upgrade error.Maybe your Multy X does not finish download the firmware because Zyxel FTP server too busy or something else. However, when download/upgrade firmware failed, Multy X will boot with original firmware. You can try it later.0
-
@Zyxel_Support
The LED of the multy was blinking more than 8 hours red, so the device never makes a restart on the old firmware.
I understand the mechanism behind it but in my case it never makes a reboot on the latest running firmware.....0 -
We will find out the solution about this situation.1
Zyxel Employee
Ally Member
Categories
- All Categories
- 442 Beta Program
- 3K Nebula
- 230 Nebula Ideas
- 131 Nebula Status and Incidents
- 6.6K Security
- 667 USG FLEX H Series
- 359 Security Ideas
- 1.8K Switch
- 86 Switch Ideas
- 1.4K Wireless
- 56 Wireless Ideas
- 7.1K Consumer Product
- 307 Service & License
- 499 News and Release
- 96 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 5K FAQ
- 34 Documents
- 89 About Community
- 111 Security Highlight