[092601]automatic Firmware update
Options
Comments
-
I just can say that it was working fine for me directly.
Got notification and upgrade went succesfull.
No manual restart needed.
Due to hat I was not at home when I start it, I couldn't tell you the LED state.
0 -
Red Blinking means FW upgrade error.Maybe your Multy X does not finish download the firmware because Zyxel FTP server too busy or something else. However, when download/upgrade firmware failed, Multy X will boot with original firmware. You can try it later.0
-
@Zyxel_Support
The LED of the multy was blinking more than 8 hours red, so the device never makes a restart on the old firmware.
I understand the mechanism behind it but in my case it never makes a reboot on the latest running firmware.....0 -
We will find out the solution about this situation.1
Zyxel Employee
Ally Member
Categories
- All Categories
- 442 Beta Program
- 3K Nebula
- 223 Nebula Ideas
- 129 Nebula Status and Incidents
- 6.6K Security
- 628 USG FLEX H Series
- 353 Security Ideas
- 1.8K Switch
- 85 Switch Ideas
- 1.4K Wireless
- 54 Wireless Ideas
- 7K Consumer Product
- 299 Service & License
- 492 News and Release
- 92 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4.8K FAQ
- 34 Documents
- 88 About Community
- 108 Security Highlight