fqdn in policy rule in zywall 110
is there a way to set up a policy to allow one or more Fully Qualified Domain Names (FQDN) through the firewall? i.e. instead of setup up a bunch of specific ip addresses which may change from time to time, I'd like to specify a set of FQDN's.
#Biz_Security_November
#Biz_Security_November
0
All Replies
-
As i check on my device, the address object does not support FQDN on ZyWall/USG series(V4.25),
Not sure will it support in the future.
I think we can inquiry on USG forum https://businessforum.zyxel.com/categories/security-zywall-usg-series
0 -
Thanks for the reply ialaland ... same conclusion I came to. Running same firmware version as you too. Thanks again.
0
Categories
- All Categories
- 414 Beta Program
- 2.3K Nebula
- 132 Nebula Ideas
- 92 Nebula Status and Incidents
- 5.4K Security
- 181 USG FLEX H Series
- 258 Security Ideas
- 1.4K Switch
- 71 Switch Ideas
- 1K Wireless
- 37 Wireless Ideas
- 6.2K Consumer Product
- 236 Service & License
- 372 News and Release
- 79 Security Advisories
- 24 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2.9K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 80 About Community
- 69 Security Highlight