My zyxel powerline won't link
Antarctica
Posts: 2 
Freshman Member
Freshman Member
Hello,
Around two years ago I purchased three power line adapters to my house. They have all worked fine up until yesterday.
Now all of a sudden since yesterday, one of them refuses to link with the others. There was a short downtime on my internet conection yesterday, and since then it won't link anymore. I tried resetting and unplugging it. I even tried to switch between sockets but without success. The other two connects nomater what, but not the last one.
What do I do?
#PLA_Aug
#PLA_Aug
0
All Replies
-
Hi,
After you reset the device, can it re-pair/sync to other PLA by pressing encrypt button? What is the LED status of homplug?
If no light and no connect to other PLA, then I guess the device broke and you should contact Zyxel or you need a new one to swap it.
0 -
The middle led, which is the link status as far as I understand is just dead. It blinks red two or three times when I reset the device, otherwise just dead.
When I try to tell no by pressing the encrypt button the power-LED just starts blinking.0 -
So after blinking, did the PLA sync to other PLA? And possible to surf internet through the PLA to each other?0
Ally MemberCategories
- All Categories
- 164 Beta Program
- 1.7K Nebula
- 86 Nebula Ideas
- 62 Nebula Status and Incidents
- 4.7K Security
- 236 Security Ideas
- 1.1K Switch
- 50 Switch Ideas
- 907 WirelessLAN
- 27 WLAN Ideas
- 5.3K Consumer Product
- 172 Service & License
- 294 News and Release
- 65 Security Advisories
- 14 Education Center
- 911 FAQ
- 399 Nebula FAQ
- 249 Security FAQ
- 90 Switch FAQ
- 100 WirelessLAN FAQ
- 18 Consumer Product FAQ
- 55 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 68 About Community
- 51 Security Highlight
Consumer Product Help Center
FAQ