NAS542 - Replacing all disks
MarVel
Posts: 1 
Freshman Member
Freshman Member
I recently bought a slightly used NAS542 with 4 x 1TB disks in RAID5.
(currently ~85% full, latest FW installed)
I'm planning to replace all 4 disks with 4 x 3TB disks but I'm a bit unsure how this is done smartest way without losing data.
Just pull one disk at time, replace, add to raid-set and wait a day until resynced and repeat 3 more times?
Or is there a better/smarter way to do this?
All advices welcome!
#NAS_Aug
(currently ~85% full, latest FW installed)
I'm planning to replace all 4 disks with 4 x 3TB disks but I'm a bit unsure how this is done smartest way without losing data.
Just pull one disk at time, replace, add to raid-set and wait a day until resynced and repeat 3 more times?
Or is there a better/smarter way to do this?
All advices welcome!
#NAS_Aug
0
Comments
-
From Zyxel user manual on page 44. ftp://ftp2.zyxel.com/NAS540/user_guide/NAS540_V5.21 ed2.pdf, you have to replace it one by one after resync done.
0
Master MemberCategories
- All Categories
- 164 Beta Program
- 1.7K Nebula
- 86 Nebula Ideas
- 62 Nebula Status and Incidents
- 4.7K Security
- 236 Security Ideas
- 1.1K Switch
- 50 Switch Ideas
- 908 WirelessLAN
- 27 WLAN Ideas
- 5.3K Consumer Product
- 172 Service & License
- 294 News and Release
- 65 Security Advisories
- 14 Education Center
- 911 FAQ
- 399 Nebula FAQ
- 249 Security FAQ
- 90 Switch FAQ
- 100 WirelessLAN FAQ
- 18 Consumer Product FAQ
- 55 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 68 About Community
- 51 Security Highlight
Consumer Product Help Center
FAQ