NAS326 UPnP not working
Dimitrij
Posts: 5 
Freshman Member
Freshman Member
Hello everyone. I just bought NAS326 and wanted to set up remote access. I synced the NAS with my PC, downloaded myzyxelcloud, updated the firmware, registered an account, set up DDNS but I am for some reason unable to set up UPnP. I checked my router settings, UPnP is enabled. I am not sure what to do. I have tried doing some port forwarding but it got me nowhere
#NAS_July_2020
0
All Replies
-
From your last screenshot, it seems your NAS had once connected but not for now.
You may check if your NAS can reach the internet (check GW, DNS setting).Use Network diagnosis to ping out, Control Panel > TCP/IP > Network Diagnosis.
Rebooting the device probably helps in some cases.
AFAIK, upnp is not working in double NAT network, so you may describe your topology as well.
0 -
I only have one router however in my router settings I have 2 UpnP "rules"
0 -
Have you tried rebooting both devices (NAS and router)?0
-
Yes
0 -
How about just use port forwarding instead? It seems usually to have upnp issue on certain cases, port forwarding is simple and easier.0
-
Ally Member
Categories
- All Categories
- 164 Beta Program
- 1.7K Nebula
- 86 Nebula Ideas
- 62 Nebula Status and Incidents
- 4.7K Security
- 236 Security Ideas
- 1.1K Switch
- 50 Switch Ideas
- 908 WirelessLAN
- 27 WLAN Ideas
- 5.3K Consumer Product
- 172 Service & License
- 294 News and Release
- 65 Security Advisories
- 14 Education Center
- 911 FAQ
- 399 Nebula FAQ
- 249 Security FAQ
- 90 Switch FAQ
- 100 WirelessLAN FAQ
- 18 Consumer Product FAQ
- 55 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 68 About Community
- 51 Security Highlight
Consumer Product Help Center
FAQ