Help Flashing PFSense on ZyXel ZyWALL USG-50
Options
Does anyone have experience flashing an old ZyXel ZyWALL USG-50 router/firewall appliance with PFSense (or even some other opensource router/firewall system like OPNSense, DD-WRT, etc)? I can't figure out how to get the ZyWALL to boot from USB.
Router is reset to factory settings and updated to the latest ZyXel firmware
I have CLI console access over the serial port
I've tried a USB stick flashed with the PFSense ISO and another one with the serial Memstick installer.
I just can't find options on the ZyWALL to make it boot from USB.
Any suggestions? Is there a way to install PFSense over LAN or over serial connection instead?
0
All Replies
-
Do you have a reason to think PFSense can run on that firewall? According to the Download Page only amd64 and 'Netgate ADI' are supported.Here is claimed that an USG 60 runs a dualcore MIPS. Don't know how the relation between an USG 50 and 60 is. MIPS is not on the download list.0
Categories
- All Categories
- 394 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 81 Nebula Status and Incidents
- 5.1K Security
- 82 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 914 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 209 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2K FAQ
- 908 Nebula FAQ
- 415 Security FAQ
- 236 Switch FAQ
- 207 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 138 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 73 About Community
- 62 Security Highlight