Wan to device access

Options
lucavengers
lucavengers Posts: 6 image  Freshman Member
First Comment
edited April 2021 in Security
Hello, I want to reach a local camera server from internet through my usg2O ZyXEL device.
Connection seems to be blocked by a firewall rule and i'm not able to see wich one.
I configure the NAT with port forwarding.
Need help please.

All Replies

  • PeterUK
    PeterUK Posts: 4,264 image  Guru Member
    250 Answers 2500 Comments Friend Collector Eighth Anniversary
    You need to make a firewall rule from WAN to LAN1 to the camera server IP
  • lucavengers
    lucavengers Posts: 6 image  Freshman Member
    First Comment
    I did the rule on Policy control because idon't have firewall on this access, I can access at the ZyXEL but i Don't go on my server I stay on the login page.

    I Don't know how to forwarding port to go on my server
  • lucavengers
    lucavengers Posts: 6 image  Freshman Member
    First Comment
    ZyXEL login page*

  • PeterUK
    PeterUK Posts: 4,264 image  Guru Member
    250 Answers 2500 Comments Friend Collector Eighth Anniversary

    You need to make a Virtual Server rule in NAT

    incoming interface = WAN

    external IP = make address with INTERFACE IP = wan1

    internal = to your camera server

    than the ports to the camera server

  • lucavengers
    lucavengers Posts: 6 image  Freshman Member
    First Comment
    POLICY CONTROL: 



    NAT:
     

     i did this but i don't know if my configuration is good because i can't access to my server 

  • lucavengers
    lucavengers Posts: 6 image  Freshman Member
    First Comment
    i do that, i think its better but doesn't work
    Policy control
     

    NAT


  • PeterUK
    PeterUK Posts: 4,264 image  Guru Member
    250 Answers 2500 Comments Friend Collector Eighth Anniversary
    edited January 2021

    You could do two NAT rules one for 80 and 443 but what you done should work.

    Does WAN1 have a WAN IP and is not getting 192.168.xxx.xxx ?

    Run a port scan for 80 and 443

    https://www.grc.com/x/ne.dll?bh0bkyd2

    Does the camera server setup with a gateway to LAN1? or is just IP and subnet?



  • lucavengers
    lucavengers Posts: 6 image  Freshman Member
    First Comment
    i think i found the problem, i have an other equipement who block with a firewall

Categories

Security Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）