Zywll 310 VPN L2TP Connection - Can't see computers on network
Options
When I connect to my VPN (Zywall 310) everything connects fine, I can ping local computers and devices on the network and I can access devices like a copier via it's web interface. However when I look at the network I don't see any of the remote local devices. I'm assuming because I can access them via IP the connection is fine but perhaps some sort of DNS setting or setup needs to be done so I can just see them under Network.
0
All Replies
-
For the VPN connection in advance is Enable NetBIOS broadcast over IPSec checked?0
-
Hi @bpworker
If establishing L2TP VPN connection successfully you can navigate Web GUI path to check L2TP user connection status: MONITOR > VPN Monitor > L2TP over IPsec > L2TP_Remote_Users just like the following picture shows.
0
Categories
- All Categories
- 384 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 80 Nebula Status and Incidents
- 5.1K Security
- 76 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 907 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 209 Service & License
- 335 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 898 Nebula FAQ
- 415 Security FAQ
- 234 Switch FAQ
- 205 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 73 About Community
- 62 Security Highlight