How to configure port failure redundancy in Zyxel GS2210 24 Port Switch?

Nebula_Adam said:

Hi @FAGHM ,

Welcome to Zyxel Community,

Kindly inform that you may use port 25-28(combo port) for your demand. The fiber port of combo port has higher priority compare to Ethernet port.

For instance, once you connect cables to fiber port and Ethernet port to both port 25, the Ethernet will be linked down as a backup port.  However I don't really recommend you to use this way. The reason is that if the fiber port 25 is not fully dead(link down), which the connected cable has low quality causes service down, it will not switch the port from optic port to Ethernet port. 

Therefore, I suggest you to use spanning tree for ports and lower down the path-cost on optic port, so the optic port will be main link. 

For example, connect Ethernet port 24 and fiber port 28 to another switch, running RSTP. If both link are running 1G, you will need to change the path cost of fiber port to lower than 4. Here is the way to use STP as redundancy. 

Note: the default value of path cost is 4 for 1 Gigabit port

Hope it helps, 

Hi
Nebula_Adam,

Thank you so much for your time and response.

I've tested the Combo port by connecting the ETH port in the corresponding port of F/O port. But it didn't work. 
Because until the SFP module is connected in the switch, its corresponding ETH port doesn't turned on (even if I totally disconnect the F/O from the SFP). Kindly tell, is there any configuration required to do this operation or it this functionality cannot be changed ?

Regarding your second solution. Let me explain you the actual scenario in more detail and then please guide me what should I do ?

I've 4 switches in the Network , Two different brand switches are connected together with a patch cord without any configuration (its required like this) . One F/O cable is coming from each switch. One is connected with Zyxcel switch  and other is connected with different model switch. "In any case I've to join these both connections." So that's why if any of the fiber is disconnected then I have to keep join all 4 switches. But If I am connecting another ETH patch cord between Zyxel and 4th Switch then whole network turn down. (Because one connection is already made between SW1 and SW2). 
So now please tell , is it possible to configure the only Zyxel switch with STP to fulfill my requirement? 
If the F/O is disconnected from SW1<-> Zyxel then ETH port (which I want to connect between Zyxel and 4th switch) will automatically turn on ? and when F/O is connected again then it will turn off automatically.?

Thanks in advance.