Dual wan failover not working
Options
Hi all,
I configured our USG40-W to be dual wan using the OPT port. I configured a trunk to spillover and set WAN1 as active, WAN2 as passive. As best I could tell all was working fine. I then configured WAN1 (advanced settings) connectivity check ICMP, 5 sec period, 1 sec timeout, 3 fail tolerance, checking address 8.8.8.8
However, when I disconnect the fiber into the modem on WAN1 no network is available. Even after about 2 minutes.
If I look at WAN1 and WAN2 they both show connected normally. When I unplugged fiber, WAN1 showed disconnected and WAN2 showed connected. However, we could not access any external sites only internal ones.
Sorry I am pretty new at this stuff. Any help would be appreciated.
Thanks in advance!
0
All Replies
-
Make two rule in network > routing
1st rule top
Incoming = Interface
member = lan1
next hop
type = Interface
interface = wan1
show advance and check enable connectivity check with a IP
2nd rule below
Incoming = Interface
member = lan1
next hop
type = Interface
interface = wan2
0
Categories
- All Categories
- 398 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 83 Nebula Status and Incidents
- 5.2K Security
- 99 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 923 WirelessLAN
- 35 WLAN Ideas
- 5.9K Consumer Product
- 212 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2.1K FAQ
- 1K Nebula FAQ
- 445 Security FAQ
- 238 Switch FAQ
- 213 WirelessLAN FAQ
- 47 Consumer Product FAQ
- 142 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight