Usg 110 does not start after push reset button, sys light never stops blinking
Options
Good evening,
after resetting my usg 110 using the front reset button, the firewall no longer starts and the sys light never stops blinking.
I can only access it via the serial console.
I have already tried the firmware restore procedure via ftp but the firewall returns an error when it tries to apply the system default configuration.
Some idea?
Thank you
0
Accepted Solution
-
Hi @Miko88
You can refer to the following procedure:
STEP1. Do reset USG110 again.
Press reset button 10 seconds and release.
(Option) STEP2. If reset fails you can refer to attachment firmware recovery procedure.
(Option) STEP3. If still appear error please provide screenshot to us.
Thanks.
0
All Replies
-
Hi @Miko88
You can refer to the following procedure:
STEP1. Do reset USG110 again.
Press reset button 10 seconds and release.
(Option) STEP2. If reset fails you can refer to attachment firmware recovery procedure.
(Option) STEP3. If still appear error please provide screenshot to us.
Thanks.
0 -
Thanks for the answer, I solved it by doing a new reset with the button. After restoring the firmware I actually didn't do it. Thank you
1
Categories
- All Categories
- 395 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 81 Nebula Status and Incidents
- 5.1K Security
- 82 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 914 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 211 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2K FAQ
- 912 Nebula FAQ
- 415 Security FAQ
- 237 Switch FAQ
- 207 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 139 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight