Invalid Administrator on GS1920-48v2
Options
Some time after installing the switch, I went to check the F/W and needed to login to upgrade but it would not recognise the 'admin'/'admin' User/Password combo....... Invalid Administrator. It had not been changed at any time. The 'Reset' switch did not do anything but did get in as admin after hitting the 'Restore' button.
Upgraded the F/W and left it at that. Couple of days later I thought I'd check the switch, once again Invalid Administrator??
Is this a common issue as I have to Recall a saved state every time I need to log in but always returns to the Invalid Administrator at some point?
Upgraded the F/W and left it at that. Couple of days later I thought I'd check the switch, once again Invalid Administrator??
Is this a common issue as I have to Recall a saved state every time I need to log in but always returns to the Invalid Administrator at some point?
0
All Replies
-
Reset button is use to reboot the device and the restore button can reset the switch to the factory default. Switch default credential should be admin/1234Is your switch run on the Nebula cloud or run as standalone mode?
Chris
0 -
On Nebula cloud0
-
Removed & unregistered from Nebula and seems to be OK now?0
-
Note that once the switch is on cloud, then the password will follow up with Nebula, you can find the password in site-wide> general settings.
Chris
0
Categories
- All Categories
- 395 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 81 Nebula Status and Incidents
- 5.1K Security
- 82 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 914 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 210 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2K FAQ
- 911 Nebula FAQ
- 415 Security FAQ
- 236 Switch FAQ
- 207 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 138 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight