Dual WAN and Port Forwarding
Options
ModHomeTech
Posts: 4
Hi,
USG110 Firewall.
Can I run a dual WAN with WAN1 being the main internet connection and WAN2 being used for port forwarding from the outside?
Also I would setup a failover feature in case WAN1 is down but most interested in the port forwarding on WAN2.
WAN1 would be LTE internet from T Mobile. They use a carrier grade nat so no access from the outside on the T Mobile system.
WAN2 would be a PTP connection being served by a fiber modem on a neighboring Island. Fiber modem has static IP address and allows for port forwarding.
USG110 Firewall.
Can I run a dual WAN with WAN1 being the main internet connection and WAN2 being used for port forwarding from the outside?
Also I would setup a failover feature in case WAN1 is down but most interested in the port forwarding on WAN2.
WAN1 would be LTE internet from T Mobile. They use a carrier grade nat so no access from the outside on the T Mobile system.
WAN2 would be a PTP connection being served by a fiber modem on a neighboring Island. Fiber modem has static IP address and allows for port forwarding.
0
All Replies
-
Nobody here knows if I can use WAN1 for everyday internet while at the same time use WAN2 to port forward into various devices on the network?0
-
Should be possible just I don't have that setup.
Is the LTE internet from T Mobile by USB?
as for WAN2 I guess you setup a PPP for a PTPP connection that you can NAT incoming connections.0 -
The LTE from T Mobile uses one of their modems that has a network jack output. That jack is connected to P1 on the USG.
The WAN2 is point to point what I was referring to as PTP. The radio has cat5 out that is connected to P2 on the USG.0 -
So PTP you need to enter user name and password by pptp, pppoe or l2tp0
-
For the PTP i have a fiber modem located on San Juan Island. That fiber modem sends internet to an Araknis 310 router. Out of the LAN on the Araknis the cat5 goes to a Cambium Force 300-25 radio and antenna. The Cambium sends the signal wirelessly 1.25 miles to Henry Island.
On Henry Island we have another Cambium Force 300-25 and the cat5 goes from this radio into P2 on the USG110.
0 -
Hi @ModHomeTech,
For that first please create 2 interface IP address object for LTE and PPPoE interfaces;
Then create new trunk interface, set LTE interface as active, PPPoE as passive;
Then please create a NAT from PPPoE interface;
Best regards.0
Categories
- All Categories
- 398 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 83 Nebula Status and Incidents
- 5.2K Security
- 99 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 923 WirelessLAN
- 35 WLAN Ideas
- 5.9K Consumer Product
- 212 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2.1K FAQ
- 1K Nebula FAQ
- 445 Security FAQ
- 238 Switch FAQ
- 213 WirelessLAN FAQ
- 47 Consumer Product FAQ
- 142 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight