USG60 ipsec to Lan2
Hi
I have a USG60 firmware 4.62 with site to site vpn on Lan1.
I want to setup ipsec IKEV2 server to client, vpn that route traffic only to Lan2.
local policy IPSEC range is 100.100.100.1 - 100.100.100.20
I can connect, but not ping or access lan2.
/Tony
I have a USG60 firmware 4.62 with site to site vpn on Lan1.
I want to setup ipsec IKEV2 server to client, vpn that route traffic only to Lan2.
Lan1 network is 176.26.11.0
Lan2 network is 192.168.41.0local policy IPSEC range is 100.100.100.1 - 100.100.100.20
I can connect, but not ping or access lan2.
/Tony
0
Accepted Solution
-
@ITB_Tony
According to your description, you can refer to the following IKEv2 VPN configuration that can be verified successfully at our lab.
Configuration > VPN > IPsec > VPN Gateway
Configuration > VPN > IPsec > VPN Connection
Establishing IKEv2 VPN connection and navigate Monitor > VPN Monitor > IPsec > to see if IKEv2 VPN IP belongs to the LAN2 domain.
1
All Replies
-
@ITB_Tony
According to your description, you can refer to the following IKEv2 VPN configuration that can be verified successfully at our lab.
Configuration > VPN > IPsec > VPN Gateway
Configuration > VPN > IPsec > VPN Connection
Establishing IKEv2 VPN connection and navigate Monitor > VPN Monitor > IPsec > to see if IKEv2 VPN IP belongs to the LAN2 domain.
1 -
Thx works good
, i have missed the "configuration Payload" option.
1
Categories
- All Categories
- 434 Beta Program
- 2.7K Nebula
- 173 Nebula Ideas
- 117 Nebula Status and Incidents
- 6.1K Security
- 408 USG FLEX H Series
- 297 Security Ideas
- 1.6K Switch
- 78 Switch Ideas
- 1.2K Wireless
- 43 Wireless Ideas
- 6.7K Consumer Product
- 268 Service & License
- 416 News and Release
- 87 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4.1K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 82 About Community
- 83 Security Highlight