[NEBULA] Is it possible to enable NAT Loopback (hairpinning) on NSG?
Options
Is there some way to enable NAT Loopback (Hairpinning) on a Nebula Security Gateway (NSG) so that I can use a domain name to connect to a NAS from on the LAN? There is a checkbox dedicated for this in the Zywalls’ web interface, but I can’t find any similar feature in neither the Nebula Control Center nor the built-in web interface.
0
Best Answers
-
Hello @nikka
Welcome to Nebula Community!
By default setting NSG will enable NAT loopback function, you don't need to configure it, is it still have the issue?
Is your client host and server located in the same subnet?Chris
5 -
Hi @nikka
One more thing I forgot to mention, if your Public IP set any, then NAT loopback will not work, you must specify the IP for it.
Chris
5
All Replies
-
Hello @nikka
Welcome to Nebula Community!
By default setting NSG will enable NAT loopback function, you don't need to configure it, is it still have the issue?
Is your client host and server located in the same subnet?Chris
5 -
Hi @nikka
One more thing I forgot to mention, if your Public IP set any, then NAT loopback will not work, you must specify the IP for it.
Chris
5 -
I see. That was my problem! Thanks a lot!0
Categories
- All Categories
- 384 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 80 Nebula Status and Incidents
- 5.1K Security
- 78 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 907 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 209 Service & License
- 335 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 898 Nebula FAQ
- 415 Security FAQ
- 234 Switch FAQ
- 205 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 73 About Community
- 62 Security Highlight