Client policy block limit?
Paulbroothaers
Posts: 1
in Nebula
Hi,
since a day or two I all of a sudden get the following message when trying to set a policy for an AP client:
since a day or two I all of a sudden get the following message when trying to set a policy for an AP client:
The thing is there aren’t any policy clients for this site and there are only 6 active SSIDs… everything worked fine before…
Any one any idea on how to resolve this?
Any one any idea on how to resolve this?
TnX in advance!
Paul
Paul
0
All Replies
-
Because maximum block policy for wireless client is 512 entries per site, site with over 512 wireless client policies after Nebula phase 12 launch can keep existing entries but cannot create additional policies until removing other wireless client entries.
You can check at: Site-wide > Monitor > Clients > Show policy clients.
If you still have any concern, please enable the Zyxel support at Help > Support request > Invite Zyxel support as administrator, and provide the Org and Site name for us to check for you.
Thank you
Regards,
Bella
0
Zyxel Employee
Categories
- 7K All Categories
- 1.4K Nebula
- 29 Nebula Ideas
- 35 Nebula Status and Incidents
- 3.9K Security
- 199 Security Ideas
- 719 Switch
- 29 Switch Ideas
- 593 WirelessLAN
- 8 WLAN Ideas
- 4.5K Consumer Product
- 97 Service & License
- 215 New and Release
- 38 Security Advisories
- 496 FAQ
- 217 Nebula FAQ
- 120 Security FAQ
- 72 Switch FAQ
- 67 WirelessLAN FAQ
- 4 Consumer Product FAQ
- Documents
- 30 Nebula Monthly Express
- 43 About Community
- 31 Security Highlight
