ATP500 assign ge1 to LAN1

Options
RafaelDalben
RafaelDalben Posts: 11 image  Freshman Member
First Comment Third Anniversary
in Security
Hi, 

I have a ATP500 but throughout the PORT SETUP I cannot assign ge1 interface to LAN1. 

Is there a WAY to solve this ?

Thanks

All Replies

  • PeterUK
    PeterUK Posts: 4,415 image  Guru Member
    250 Answers 2500 Comments Friend Collector Eighth Anniversary

    Go to object > zone and move ge1 out of any zone and move it to LAN1

  • RafaelDalben
    RafaelDalben Posts: 11 image  Freshman Member
    First Comment Third Anniversary
    BHi Peter, thx for your reply.

    But in INTERFACE / PORT / Port Group, I still can't drag the ge1 to LAN1. 


  • PeterUK
    PeterUK Posts: 4,415 image  Guru Member
    250 Answers 2500 Comments Friend Collector Eighth Anniversary
    edited November 2021
    But if you go to object > zone can you move ge1/ge1_ppp out of say WAN/OPT?
  • RafaelDalben
    RafaelDalben Posts: 11 image  Freshman Member
    First Comment Third Anniversary

    Sorry, I meant drag P1 to LAN1
  • RafaelDalben
    RafaelDalben Posts: 11 image  Freshman Member
    First Comment Third Anniversary
    Hi,

    Yes, I did move the ge1 and ge1_ppp out of WAN and inserted into LAN...


    But I still can't drag the P1 to LAN1
  • PeterUK
    PeterUK Posts: 4,415 image  Guru Member
    250 Answers 2500 Comments Friend Collector Eighth Anniversary

    Either its a bug or limitation


  • Zyxel_Cooldia
    Zyxel_Cooldia Posts: 1,570 image  Zyxel Employee
    Zyxel Certified Network Administrator - Security Zyxel Certified Sales Associate 100 Answers 1000 Comments
    edited November 2021
    Hi @RafaelDalben,
    ge1 interface is SFP, it's different PHY type as compared to ETH.
    That's a limitation to port grouping.

Categories

Security Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）