ARP flood by Enable Connectivity Check for routing
Options
Is their a setting where I can disable ARP check then ping IP for Connectivity Check?
I would like to use a 5sec check period but not to ARP the gateway and use last known ARP check for the gateway.
As I have 4 routing rules and doing Connectivity Check it makes the Zywall 110 ARP every second~
Also I'm doing the same ping IP for the checks might it be better for the USG to look at all the Connectivity Checks going out the same interface and do one instead of four?
Thanks
0
All Replies
-
Hi @PeterUKThanks for your feedback and the behavior is by designWhen set the Policy Route with Heath Check.It send arp request before ICMP.No matter ping the same address or not.Thanks your advice.We will put this idea to our future development evaluation.Thanks youKevin0
Categories
- All Categories
- 396 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 81 Nebula Status and Incidents
- 5.1K Security
- 86 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 916 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 211 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2K FAQ
- 912 Nebula FAQ
- 419 Security FAQ
- 237 Switch FAQ
- 207 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 139 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight