USG210 NAT 1:1 howto
Hi,
I have one provider and multiple public IPs. One of it is zywall address.
When i whant to take some ports outside i do new NAT 1:1 port mapping to one of my IPs (not default). When i go to my server from the internets all is ok, but when i go outside, using this server, i go with zywall ip. I create new virtual wan with the address that is used by my server. Same result. Why?
I have one provider and multiple public IPs. One of it is zywall address.
When i whant to take some ports outside i do new NAT 1:1 port mapping to one of my IPs (not default). When i go to my server from the internets all is ok, but when i go outside, using this server, i go with zywall ip. I create new virtual wan with the address that is used by my server. Same result. Why?
0
Accepted Solution
-
the problem was in routing)0
All Replies
-
the problem was in routing)0
Categories
- All Categories
- 415 Beta Program
- 2.5K Nebula
- 152 Nebula Ideas
- 101 Nebula Status and Incidents
- 5.8K Security
- 296 USG FLEX H Series
- 281 Security Ideas
- 1.5K Switch
- 77 Switch Ideas
- 1.1K Wireless
- 42 Wireless Ideas
- 6.5K Consumer Product
- 254 Service & License
- 396 News and Release
- 85 Security Advisories
- 29 Education Center
- 10 [Campaign] Zyxel Network Detective
- 3.6K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 87 About Community
- 76 Security Highlight
