WAN schedule nebula control centre
Hi all,
I need to alternate between WAN1 and WAN2 on a daily schedule.
On ATP500 local interface I can create a schedule on the policy route page.
Is there a way to do so in the nebula centre?
I would like to move my ATP500 over to nebula but I need this function.
I need to alternate between WAN1 and WAN2 on a daily schedule.
On ATP500 local interface I can create a schedule on the policy route page.
Is there a way to do so in the nebula centre?
I would like to move my ATP500 over to nebula but I need this function.
0
All Replies
-
Hi,
Any help on this please?0 -
Hi @Carlo
In the default setting, system will auto route traffic between WAN1 and WAN2 for load balancing.
Of cause you can configure Backup(passive) interface for failover scenario.
As current design, schedule profile could only work in Security Policy rules.
According to your requirement to scheduling route road automatically seems unable to achieve in current configuration. I will report it to idea section for new enhancement in the future.
You can still change routing roles by manually changing "Backup Internet" setting.0
Categories
- 6.8K All Categories
- 1.4K Nebula
- 29 Nebula Ideas
- 35 Nebula Status and Incidents
- 3.9K Security
- 200 Security Ideas
- 723 Switch
- 30 Switch Ideas
- 598 WirelessLAN
- 8 WLAN Ideas
- 4.5K Consumer Product
- 98 Service & License
- 214 New and Release
- 38 Security Advisories
- 510 FAQ
- 235 Nebula FAQ
- 117 Security FAQ
- 72 Switch FAQ
- Network Reliability
- Network Security
- IPTV
- Layer 3 Switching & Routing
- Surveillance / ONVIF
- Other Topics
- 65 WirelessLAN FAQ
- 5 Consumer Product FAQ
- Documents
- 30 Nebula Monthly Express
- 43 About Community
- 31 Security Highlight