USG ATP / FLEX high CPU usage -> reboot: doesn't come up, SYS blinking forever
All Replies
-
Zyxel_Stanley said:Hi @OverWire
If you updated signature and device is unable to boot up success, you can swap to the other partition to boot up your system.
(1) Reboot your device and enter to debug mode.
(2) Enter "atcd 1" or "atcd 2" to change system boots partition.
(3) Enter "atgof" to restart system again. (or power recycle again)
This can solve temporay the problem only if are not managed in Nebula.
0 -
Dear @overwireOverWire said:Zyxel_Stanley said:Hi @OverWire
If you updated signature and device is unable to boot up success, you can swap to the other partition to boot up your system.
(1) Reboot your device and enter to debug mode.
(2) Enter "atcd 1" or "atcd 2" to change system boots partition.
(3) Enter "atgof" to restart system again. (or power recycle again)
This can solve temporay the problem only if are not managed in Nebula.Almost correct.. it should be atgo not agof. That is the correct way.
0
Freshman Member
Zyxel Employee
Categories
- All Categories
- 164 Beta Program
- 1.7K Nebula
- 86 Nebula Ideas
- 62 Nebula Status and Incidents
- 4.7K Security
- 236 Security Ideas
- 1.1K Switch
- 50 Switch Ideas
- 907 WirelessLAN
- 27 WLAN Ideas
- 5.3K Consumer Product
- 172 Service & License
- 294 News and Release
- 65 Security Advisories
- 14 Education Center
- 911 FAQ
- 399 Nebula FAQ
- 249 Security FAQ
- 90 Switch FAQ
- 100 WirelessLAN FAQ
- 18 Consumer Product FAQ
- 55 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 68 About Community
- 51 Security Highlight
